Third generation daylight switching

Why use the Powersaver Daylight Switching system?
Quality sensor, powerful logic and remote control

• Re-Strike Delay
  Protects your lamps and fittings
• Dead-band
  Reduces switching on a cloudy day
• Intelligence / Adaptive
  Will monitor sensor and reduce switching
• Remote control
  No need to get at the sensor
• Pre-set levels (1000, 600, 300 20 Lux)
  Light level can be set day or night
• Customisable light level
  Set your preferred light level exactly
• European engineering

Beware of cheap imitations!
Previous generations of daylight switching turned the lights on and off rapidly which is a danger to your light fittings and can cause them to fail. In the worst case lamps can explode sending a shower of fine glass and mercury powder down into the workplace.
Cheap sensors don’t read light levels accurately and can leave your workers with too little light to work safely. Some turn lights off at night leaving everyone in the dark!

This third generation ‘smart switch’ has powerful logic backing it up to reduce false switching and the flexible control to change the light setting on the run to suit you. No other daylight system in Australia has the functionality Powersaver delivers.

Pulse Start Metal Halide Dimming

If you are renewing your lighting and opt for Pulse Start Metal Halide we can oversee an energy saving system that will dim the lights in proportion to the available daylight. This is a complete fitting and lighting control replacement as used in Bunnings stores around Australia.

Like the above system the controller is a logic unit and has delay and a special lamp burn in program.

Pulse start metal halide is great in very hot environments where fluorescent lighting may not be suitable.